Loading ...
Loading ...
Loading ...
!
!
&$87,21
Make sure vacuum cleaner is turned off and not
plugged into a power source.
:$51,1*Do not attempt to remove belt.
Call the Eureka Customer Service HELPLINE
at 1-800-282-2886.
10
Eureka Customer Service HELPLINE 1-800-282-2886
+RZWRPDLQWDLQ\RXUYDFXXPFOHDQHU
&$87,21
Never operate vacuum
FOHDQHUZLWKRXWDOOÀOWHUV
ÀOWHUVFUHHQDQGGXVWFXS
in proper position.
:$51,1*Moving parts!
Recharge cleaner after
each use.
2. Brush roll can then be lifted out
by pulling up on the left side
(indicated by the red tip). Any
threads, hair or debris can be cut
away with scissors or using the
included brush cleaner. Be sure to
remove any hair or strings which
may have wrapped around the tips of the brush roll.
3. Replace brush roll and push down to ensure it is correctly in
place with the red tipped end of the brush on the left side.
Replace lid and push down until it clicks.
1RWH If spinning brush is curled, you can remove it and place in
warm water for 30 seconds and then let it thoroughly dry. Also
regularly use the brush cleaner to remove dust, debris and hair
from the spinning brush. Brushroll frame can also be removed and
cleaned but lifting out. When putting back in ensure the side with
UXEEHUÁDSLVRQWKHVLGHFORVHVWWRWKHGXVWELQ
1. Press dust cup release button to remove
dust cup from robot.
:DVKDEOHEUXVKUROO²FOHDQIUHTXHQWO\
Every three months, rinse
and dry the brush roll, spinner
EUXVKDQG+(3$ÀOWHUWKHQGU\
thoroughly for at least 24 hours.
+RZWRPDLQWDLQEUXVKUROO
7RDYRLGXQQHFHVVDU\VHUYLFHFDOOVSHULRGLFDOO\FKHFNEUXVKUROOIRUGHEULV,IEUXVKUROOJHWVFORJJHG
LWZLOODXWRPDWLFDOO\VKXWRII7XUQYDFXXPRIIEHIRUHDWWHPSWLQJWRUHPRYHFORJ
1. Press brush roll release button on top of
robot and lift center unit out.
2. Hold dust cup over trash can and press
the easy empty release button.
3. Thoroughly clean dust cup. Lid can also
be opened from top to remove additional
debris that may be stuck.
2SHQOLGWRDFFHVVDQGUHPRYH+(3$ÀOWHUDQGVKDNHWR
UHPRYHGXVW5HSODFH+(3$ÀOWHUHQVXULQJWKDWGXVWDQG
GHEULVGRHVQ·WIDOOLQWRWKHRSHQLQJEHKLQGWKHÀOWHUDQGWKHQ
SXVKÀOWHUHGJHVWRHQVXUHLWFOLFNVEDFNLQWRSODFH
5. Close top and bottom lid until they both click in to place and
place the dust cup back on the robot until it clicks into place.
Regularly use a dry cloth to remove dust and debris from cliff sensors,
charging contacts and sensors on front bumper to ensure they are not blocked.
'XVWFXS²(PSW\DIWHUHDFKXVH
Loading ...
Loading ...
Loading ...