Loading ...
Loading ...
Loading ...
13
Removing and refitting the door panels
The glass panels can be removed from the oven door to allow
more thorough cleaning.
Removal
1. Removing the oven door See the section Removing the oven
door. Lay the oven door on a cloth with the handle facing
downwards.
2. Remove the cover from the top of the oven door. To do this,
press with your fingers on the left and right-hand side. Pull
out the cover (Fig. A).
3. Raise the top panel and pull it out (Fig. B).
Clean the panels with glass cleaner and a soft cloth.
: Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting
1. Hold the top glass panel firmly by the sides and slide it in
towards the back at an angle. The panel must be inserted
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).
2. Place the cover on the top of the oven door and press in
place. Make sure that the grooves along the sides lock into
position.
3. Refitting the oven door See the section Refitting the oven
door.
Do not use the oven again until the panels have been
correctly fitted.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio, where you will
find plenty of cooking tips and tricks.
: Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Caution!
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
Error messages
When the display panel shows an error message with “, press
the
0 button. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
: Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
%$
$
Problem Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut Check whether the kitchen
light or other kitchen appli-
ances are working.
The clock dis-
play flashes.
Power cut Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
Error message Possible cause Solution/advice
“‹‚‚
A button has
been pressed
for too long or
has got stuck.
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
Loading ...
Loading ...
Loading ...