Loading ...
Loading ...
Loading ...
7
Installation
• Remove the exterior and interior packing.
Before Using Your Appliance
• CAUTION: After unpacking and before connecting the appliance
to the power source, you MUST allow this appliance to stand
upright for at least 2 hours to allow the lubricant and refrigerant to
drain back into the compressor and stabilize. Failure to do so may
adversely affect performance and the lifetime of this unit.
• Clean the interior surface with a soft cloth dampened with
lukewarm water.
• The appliance is specially designed for wine and/or beverage
storage; please do not put in other goods.
This appliance is designed for free standing or built-in (fully recessed)
installation. If
Installation
free standing, the unit should have at least 4” of
clearance at both sides, at the top and at the back to allow for
adequate ventilation. If it is
built-in
• Place the appliance on a floor that is strong enough to support it
when it is fully loaded. To level the unit, adjust the front leveling leg
at the bottom.
, leave at least 3/16” at both sides,
1/16” at the top and 2” at the rear. Be sure that airflow under the
appliance is not blocked.
• Locate the appliance away from direct sunlight and sources of heat
(stove, heater, radiator, etc.).Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
Extremely cold ambient temperatures may also cause the unit not
to perform properly.
• Avoid locating the unit in moist areas.
• Plug into the proper power socket. Make sure that the shape and
voltage of the socket is consistent with the nameplate on the back of the
unit.
Loading ...
Loading ...
Loading ...