Loading ...
Loading ...
Loading ...
7.
While holding the other end of the rear
axle shaft with a wrench, remove the rear
axle nut.
8.
Pull the rear axle shaft out and remove
the side collar.
9.
Move the wheel to the right to separate it
from the final drive gear case.
10.
Remove the wheel.
Installation
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste.
Recommended molybdenum disulfide
paste:
(USA only) Pro Honda Moly 60 Paste or
equivalent
1.
Position the wheel between the swingarm
and the final drive gear case.
u Be sure the splines on the wheel hub
fit into the final drive gear case.
2.
Install the side collar into the brake panel.
3.
Insert the rear axle shaft from the right
side, through the right swingarm, brake
panel, wheel hub and final drive gear
case.
20180808121829_31MJA8100_enu_BOOK Page 93 Wednesday, August 08 2018 12:24:26 JST
Tire Puncture u Removing Wheels
Troubleshooting
90
Rear
axle nut
Loading ...
Loading ...
Loading ...