Loading ...
Loading ...
Loading ...
16
OPERATION
Fig. 10
INSTALLINg STRINg IN STRINg HEAD (See Figure 9.)
1. Line up the slots on the spool cap with the slots
on the string head.
2. Insert line through the string head hole. Push line
until it exits the opposite string head hole.
3. Pull the line through until there is an equal
amount of line on each side.
4. Turn the spool cap clock-wise to begin
winding the string into the string head. Leave
approximately 5 inches of string protruding out of
each side of the head.
It is recommended that .080” line Diameter be used
for this string head.
Note: Do not put more than 15 feet of line in at a time.
Spool Cap
String Head
String Head Hole
Slots
Fig. 9
REmOVINg / REPLACINg STRINg HEAD (See Figure 10.)
1. Line up the spacer hole up with the hole in the gear box.
2. Place a small screw driver or metal rod (Not included) in the spacer hole.
3. Rotate the head clockwise to loosen and remove.
4. Reverse steps 1.-3. to reinstall the same string head.
Note: If you put a different model string head on this unit please follow the manufacturer’s instructions to
install that head.
SPACER HOLE
mETAL ROD
Loading ...
Loading ...
Loading ...