Loading ...
Loading ...
Loading ...
11
Proceed as follows:
1. Fill the tank with the descaler solution, obtained by dilut-
ing the descaler with water following the instructions on
the pack;
2. Turn the selector dial to the ON position;
3. Make sure the lter holder is not attached and place a re-
cipient under the cappuccino maker;
4. Wait until the READY light comes on;
5. Turn the selector to the
position and deliver
about 1/4 of the solution in the tank: from time to time
turn the steam dial to the
position
to discharge
steam.
Then interrupt delivery by turning the selector to
the ON position and leave the solution to work for about 5
minutes;
6. Repeat point 5 another 3 times, until the tank is empty;
7. To eliminate residues of descaler solution, rinse the tank
well and ll it with clean water (without descaler);
8. Turn the selector to the
position and deliver water
until the tank is empty;
9. Repeat points 7 and 8.
PROBLEM POSSIBLE CAUSE SOLUTION
No espresso coee is delivered No water in the tank Fill the tank with water
The holes in the lter holder are blocked Clean the lter holder spout holes
The espresso boiler outlet is blocked Clean as described in the “Cleaning” section
Limescale in the water circuit Descale as described in the “Descaling” section
The espresso coee drips from
the edges of the lter holder
rather than the holes
The lter holder has been inserted incor-
rectly or is dirty
Attach the lter holder correctly and rotate rmly
as far as it will go
The holes in the lter holder spouts are
blocked
Clean the lter holder spout holes
The espresso boiler gasket has lost elasti-
city or is dirty
Have the espresso boiler gasket replaced by Custo-
mer Services
The espresso coee is cold The READY light is not on when the coee
delivery button is pressed
Wait until the OK light comes on
No preheating was done Pre-heat as indicated in the “Tips for a hotter cof-
fee” section
The cups were not preheated Pre-heat the cups with hot water
Limescale in the water circuit Descale as described in the “Descaling” section
The pump is excessively noisy The water tank is empty Fill the tank
The tank is not correctly in place and the
valve on its base is not open
Press the tank down lightly to open the valve on
the bottom
There are air bubbles in the tank
connector
Follow the instructions given in the “Hot water”
section until water is delivered
TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
Loading ...