Loading ...
Loading ...
Loading ...
4
WARNING
TIP OVER HAZARD
Appliance is top heavy and tips easily
when not completely installed. Keep
doors closed until appliance is completely
installed and secured per installation
instructions.
Use two or more people to move and install appliance.
Failure to do so can result in death or serious injury.
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power or turn
power disconnect switch to
OFF position before removing top grille.
Failure to do so can result in death or electrical shock.
A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local ordinances.
• The required use of a GFI is normally related to the location of a receptacle with respect to any signi cant sources of water or moisture.
• Viking Range, LLC will
NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the
requirements below.
If the use of a GFI is required, it should be:
• Of the receptacle type (breaker type or portable type
NOT recommended)
• Used with permanent wiring only (temporary or portable wiring
NOT recommended)
• On a dedicated circuit (no other receptacles, switches or loads in the circuit)
• Connected to a standard breaker of appropriate size (GFI breaker of the same size
NOT recommended)
• Rated for Class A (5 mA +/- 1 mA trip current) as per UL 943 standard)
• In good condition and free from any loose- tting gaskets (if applicable in outdoor situations)
• Protected from moisture (water, steam, high humidity) as much as reasonably possible
Power On/O Switch
Your unit is shipped with the power switch on. When rst plugged in, the
display will ash. Push any button to initiate display.
The power on/o switch is located to the left of the center behind the
header panel. It is used to turn the power o when cleaning or servicing the
refrigerator.
To turn the power o , remove the header panel by using a small at head
screwdriver to pry between the breaker frame and the header panel on the
side closest to the hinge (see drawing A). There is a small pocket cut into the
bottom of the header panel at that location for that purpose. Once you have
pulled the header panel away from the unit (drawing B) enough to get your
ngers behind it slowly pull the opposite side away from the unit.
NOTE: There are wires connected to the backside of the header panel for the
Viking light and the WiFi board on the back of the light.
To turn power on, press power on/o switch to the on position. Replace
header panel. IMPORTANT: Be sure the power on/o switch is in the on
position after cleaning or servicing.
power switch
IMPORTANT – Please Read and Follow!
A
B
Loading ...
Loading ...
Loading ...