Loading ...
Loading ...
Loading ...
10
EXERCISE COMPUTER
FUNCTION BUTTONS:
MODE: Press to select functions.
Press and hold the MODE button for 3 seconds to reset time, distance, and calories.
SET: Press to set values of time, pulse, distance, and calories when not in scan mode.
Press the MODE button to cycle through functions: time, distance, and calories to select desired
function. Use the SET button to set a value for time, distance, or calories. The value of a function will
be set on a countdown. Press the MODE button once more, to save the function value you’ve created.
RESET: Press to reset time, pulse, distance, and calories to zero when not in scan mode.
OPERATION FUNCTIONS:
SCAN: Press MODE button until “▼” appears at SCAN position (or until “SCAN” appears), the
computer will rotate through all 5 functions: Time, Speed, Distance, Calories, and Total Distance. Each
display will be held for 6 seconds.
TIME: Counts the total time of the exercise from start to finish.
SPEED: Displays the current speed.
DISTANCE (DIST): Counts the distance of an exercise from start to finish.
CALORIES (CAL): Counts the number of total calories burned during an exercise from start to finish.
TOTAL DISTANCE (ODO): Counts the total distance after installing the batteries.
AUTO ON/OFF & AUTO START/STOP: If the wheel is in motion or if any button is pressed, the
computer will become active and shall remain active until it’s been inactive for 8 minutes. Then, the
power (computer) will turn off automatically.
PULSE RATE: Press MODE button until “▼” appears at PULSE position, (or until “ ” appears). To
properly measure your pulse rate, you must place both your palms on the hand pulse sensors located
on the handlebar next to the seat.
Remark: During the process of pulse measurement, the measurement value may be higher than virtual
pulse rate during the first 2~3 seconds, after which it will return to normal level. To ensure testing
accuracy, it is suggested that user test pulse during stop/pause exercise to avoid any possible influence.
The measurement value cannot be regarded as the basis of medical treatment.
ALARM: The functions of time, distance, and calories can be set to countdown, if any of the above
value goes to zero, the computer will beep for 15 seconds.
Press MODE to select the function, then press SET to adjust the value.
Loading ...
Loading ...