Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
5
SETUP
1. Find a suitable surface to place the mattress on.
2. Make sure the surface is at and free of sharp objects.
3. Fold out the mattress so it is in full length.
4. Place the mattress on the substrate so that the valve is easily accessible.
5. Screw the cap of the valve opening as shown in Fig.
6. Install the air pump as shown on picture 2.
NOTE: Always use a manual pump. NEVER use a compressor to pump up the
mattress.
7. Pump the mattress up to the desired air pressure. The air pump is equipped
with BAR meter as shown in picture 3. See pressure scale in the manual.
NOTE: Never pump the mattress up to 1.5 bar.
8. Replace the cap on the valve opening.
9. If the pressure on the mattress is to be down-regulated, unscrew the cap from
the valve opening and press the valve as shown in picture 4.
Screw the cap on the valve opening again after adjustment.
Your Training Air Mat is now ready for use. Enjoy!
PACKING
Always have good patience when packing the mattress.
1. Remove all objects on the mattress.
2. Press the valve all the way in and release again so that the valve snaps into
open position as shown in Figures 5 and 6. Press the valve in the bottom and
release again to close the valve again.
3. Carefully press all air out of the matress and fold it together. Make sure to dry
the dirt and dirt of the mattress as it folds.
• Pack older a damp mattress together.
• If the valve is loose, it can be tightened by attaching the valve handle to the
valve and turn the valve clockwise as shown in Figure 7.
Be careful not to over-tighten the valve.
Loading ...
Loading ...
Loading ...