Loading ...
Loading ...
Loading ...
Important Tips before Use
Preparation
Install the side brushes before use. Please note L and R should correspond to
each other when installing the side brushes.
Turn on the main power switch on the side of V300.
Remove before use
Place the Charging Base on a hard, level surface and against a wall.
Remove power cords and small objects from the floor that may become
entangled with the V300.
The V300 may climb on top of objects less than 0.63 in/16 mm in height.
Remove these objects if possible.
Do NOT stand around narrow places, such as thresholds and aisles, to reduce
the uncovered rate.
The V300 will clear all memories and re-plan all work routes if it is manually
moved or it is controlled by the remote control during cleaning. To ensure it
works efficiently, please do NOT arbitrarily move V300 manually or operate it by
remote control during cleaning.
Anti-drop sensors prevent the V300 from tumbling down stairs and steep
drops. They may work less effectively if they are dirty or used on reflective/very
dark-colored floors. It is recommended that physical barriers are used to block
off areas where the V300 may fall.
Please make sure all furniture is properly organized so that the V300 is able to
clean well without becoming stuck.
1
1
1
2
2
3
4
2
3
3
4
4
5
5
6
6
3. Using Your V300
5 6
Do not place any objects within 3.3 ft. to the left / right and 6.6 ft. to the
front of the charging base, Please do NOT place the charging base close to
Doors, Mirrors or other reflective objects within this range.
Loading ...
Loading ...
Loading ...