Loading ...
Loading ...
Loading ...
12
WARNING
NEVER ADJUST THE BURNER SO LOW THAT IT MAY
GO OUT DURING USE. DO NOT OPERATE THE SIDE
BURNER WITH THE LOW HEAT SCREW REMOVED.
GAS CAN ESCAPE AND CAUSE A POTENTIALLY
HAZARDOUS CONDITION.
NOTE: The first burner may take longer to light while air is purged from the gas supply system.
If the burner does not light in 4 seconds, turn knobs to “OFF” and wait 5 minutes to allow any accumulat-
ed gas to dissipate before trying again. If the burner will not light after several attempts, then it can be
lit with a match.
Keep your face away from the Side Burner as far as possible and pass a lit, long stem match through
the Side Burner grate the ports of the burner you are trying to light. When attempting to light a burner
with a match, ensure that the correct burner control knob is used.
Position the match near the burner ports. Push and turn the control knob to “HI”. Repeat procedure on
each burner if necessary. If the burner does not light in 4 seconds turn the knob OFF, wait 5 minutes
and try again. If the burner will not light after several attempts see page 14: Troubleshooting.
BUTTON SYMBOLS AND LOCATIONS:
There is only one button to engage the igniter located on the upper
right corner of the front panel of the Side burner.
BURNER ADJUSTMENTS
LOW HEAT SETTING ADJUSTMENT:
NOTE:
THE LOW HEAT SETTING ON YOUR
SIDE BURNER IS PRESET AT THE
FACTORY.
ADJUST ONLY IF ALTITUDE OR ENVI-
RONMENTAL FACTORS ARE CAUSING
POOR, LOW HEAT, PERFORMANCE.
IGNITER BUTTON SWITCH
(on RIGHT side)
Figure # 4
PUSH & TURN TO “HI”
PUSH TO
IGNITE
Loading ...
Loading ...
Loading ...