Loading ...
Loading ...
Loading ...
15EN
• [DRC]
• [Prune]
• [System]
3 To select an option, press ENTER.
4 Repeat step 2-3 if sub-option is available
under one option.
Full scan
Full scan is used to perform a wide range of
DAB radio search.
1 In the DAB mode, press MENU to enter
the menu options.
2 Press / repeatedly until [Full scan]
displays.
3 Press to conrm the selection.
» Full scan starts automatically.
Manual tune
With this feature, you can tune to a specic
channel/frequency manually. In addition to
antenna orientation for better radio reception,
the optimal reception can also be obtained with
this feature.
1 In DAB mode, press MENU to display the
[Manual tune] option.
2 Press ENTER to conrm the selection.
» The display shows a channel and its
frequency.
3 Press / repeatedly until the desired
channel/frequency appears.
4 Press ENTER to conrm the selection.
Tip
• You can press RDS/DISPLAY to change the service
information on the display.
• You can adjust the position of the antenna to obtain
the optimal signal strength.
Dynamic Range Control (DRC)
DRC adds or removes a degree of
compensation for the differences in the dynamic
range between radio stations.
There are three levels of compensation:
• [DRC Off]: No compensation applied.
(the default)
• [DRC Low]: Maximum compensation
applied.
• [DRC High]: Medium compensation
applied.
1 In DAB mode, press MENU to enter the
menu options.
2 Press / repeatedly until [DRC]
displays.
3 Press ENTER to enter the sub-menu.
» The current DRC level displays on the
rst line.
4 Press / to select a DRC value
» [DRC Off], [DRC Low] and [DRC
High] displays on the second line.
5 Press to conrm the selection.
» You should be able to hear the
difference in compression immediately.
Note
• The best way to determine which of these DRC value
settings suits you best is to experiment with them on
various source material.
Prune
This option lists active stations and removes any
stations that are in the list but have no service
in your area from the service list. Those invalid
stations in the service list have a question mark
(?) displayed in front of the station name.
1 Select Prune stations and press .
» All stations that have a question mark
are deleted from the service list.
System
• [Factory reset]: Reset all the settings
of this unit to factory default. Press
to conrm reset.
• [SW version]: Display software version
of the unit.
Loading ...
Loading ...
Loading ...