User Manual - Page 27

For HTM 1720 V.

Loading ...
Loading ...
Loading ...
27
CLEANING AND MAINTENANCE
Vacation
1. Empty the refrigerator and freezer compartments.
2. Disconnect the appliance from the power supply.
3. Defrost the freezer compartment, and clean and dry both
compartments.
4. Leave the doors open to prevent formation of unpleasant odours.
TROUBLESHOOTING GUIDE
1. The appliance is not working.
• Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the double-pole switch on?
• Has the fuse blown?
• Is the power cord damaged?
• Is the thermostat set to 0 (Stop)?
2. Temperature inside the compartments is
not low enough.
• Is the door shut properly?
• Is the appliance installed near a heat source?
• Is the thermostat setting correct?
• Are the air circulation grilles blocked?
3. Temperature inside the refrigerator
compartment is too low.
• Is the thermostat setting correct?
4. Water collects at the bottom of the
refrigerator compartment.
• Is the defrost water drain blocked?
5. The inside light is not working.
Perform the checks for problem 1, and then:
• Disconnect the appliance from the power
supply.
To inspect the bulb, refer to the instructions
and illustration on the attached table.
• Check the bulb and replace it, if necessary,
with a new one. Replace using maximum
15W bulb.
6. Excessive frost build-up in the freezer
compartment
• Is the door shut properly?
• Is food obstructing proper door closure?
Attention:
The front edge of the appliance may be hot.
This prevents the formation of condensation
and is not a defect.
Gurgling and hissing noises due to expansion in
the refrigerant circuit are normal.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself with
the help of the “Troubleshooting guide”).
2. Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
the nature of the problem
the appliance model,
the Service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance)
your full address
your telephone number and area code.
Note
The door opening direction can be changed.
If this procedure is performed by the After-
Sales Service it is not covered by warranty.
Loading ...
Loading ...
Loading ...