Loading ...
Loading ...
Loading ...
7
Step 9 – Attach Reflector Assembly to Studs
. Support Heater.
. Slide 3 Large Flat Washers over threaded end of
Studs.
. Locate Reflector Assembly on 3 studs.
. Install large flat washers on studs & securely tighten
wing nuts but do not over-tighten!
Step 10 – Connect Hose & Regulator to Cylinder
. You must provide
propane gas and
propane cylinder. Use a
standard 20 lb. propane
cylinder only.
. Use this heater only
with a propane vapor
withdrawal supply
system. See Chapter 5
of the Standard for
Storage and Handling
of Liquefied Petroleum
Gas, ANSI/NFPA
58.Your local library or
fire department will have this book.
. A minimum supply pressure of 11.0 W.C. is required
for the purpose of input adjustment for propane gas.
. The pressure regulator and hose assembly supplied
with the appliance must be used.
. The installation must conform with local codes, or in
the absence of local codes, with National Fuel Gas
Code, ANSI Z223.1.
. A dented, rusted or damaged propane cylinder may
be hazardous and should be checked by your cylinder
supplier. Never use a propane cylinder with a
damaged valve connection.
. The propane cylinder must be constructed and
marked in accordance with the specifications for LP
gas cylinders of the U.S. Department of
Transportation (DOT).
. Never connect an unregulated propane cylinder to the
heater.
. Lift Cylinder Housing.
. Screw regulator onto gas hose. Do not cross-thread.
. Tighten securely.
. Attach regulator to cylinder.
.Complete attachment.
.Install cylinder.
Standard 20 lb. tank
6 Req’d Large Flat Washers
3 Req’d Wing Nuts
Loading ...
Loading ...
Loading ...