Loading ...
Loading ...
Loading ...
24 CLEANING AND CARING FOR THE ELEVATED COOKER
CLEANING AND CARING FOR THE ELEVATED COOKER (CONTINUED)
Re-Assembling the oven door inner glass
• Position the inner glass back onto the door.
• The Electric elevated has a heat reflective coating
on the inner glass. When positioning the glass back
onto the door, the black dot on the glass should be
in the top left or bottom right corner when viewed
from the front.
• Replace the top trim ensuring the clips snap back
into position.
• Fully open the door, rotate the stirrups back to their
original position and close the door.
WARNING
WARNING
DO NOT use the oven without the inner door glass fitted.
DO NOT use harsh abrasive cleaners or sharp metal
scrapers to clean glass since they can scratch the surface,
which may result in shattering of the glass.
DO NOT place glass in dishwasher.
SAFETY WARNINGS ABOUT CLEANING
WARNING
WARNING
ALWAYS make sure that the cooker is turned off
before cleaning.
WARNING
CAUTION
ALWAYS clean cooker immediately after use.
DO NOT use steam cleaners. These may cause
moisture build-up, especially in the glass door.
DO NOT use caustic based cleaners or harsh abrasives.
These will damage your oven.
INSTALLING THE OVEN LIGHT
WARNING
WARNING
Ensure appliance is switched off at power supply (not
just the control knobs) before replacing the light globe to
avoid possibility of electric shock.
Cleaning the Oven Door
This product has a removable inner glass door for ease of
cleaning.
To remove the inner door glass for cleaning
• Open the door fully to access the hinges then rotate
the ‘stirrups’ on both hinges fully towards the door.
• Slowly close the door until it stops against the
‘stirrups’.
• To then remove the top trim, press the ribbed release
clips at each end and lift top trim away from the door.
• Using both hands, gently remove the inner glass by
sliding out and lifting away from the door.
• Hand wash only with a soft cloth and warm soapy
water. When dry, polish with a soft cloth and ensure
the glass is dry before re-assembly.
• Wipe inner and outer glass gently with detergent
and warm water.
• Wipe clean and dry thoroughly.
Turn oven light glass
anti-clockwise to
remove for globe
replacement
A special high temperature resistant globe should
be used. This can be purchased from the Electrolux
Customer Care Centre. Light globes are not covered
by warranty.
Loading ...
Loading ...
Loading ...