Loading ...
Loading ...
Loading ...
10
English
AC Mains (Power) Connection
Note: Please ensure the voltage switch adheres to
your regional guidelines.
Before you plug in the Descend subwoofer, please
make sure the voltage switch on the back of the
subwoofer is set to your country’s voltage output.
The voltage switch typically will not need to be
changed unless you purchased your product from
a different region than where you will be using it. If
necessary, adjust the switch now prior to plugging in
the subwoofer.
The subwoofer has two Auto On/Off functions:
• Always on
• Auto on via signal (recommended)
Please note that if you hear a noise from the speaker
when the amp powers up or down, this is normal.
The bi-color blue/red LED on the back panel will
light up when a signal is detected and the amplifier
turns on. The LED is red when in standby mode
and no signal is detected. Please note that after the
cessation of a signal, it may take up to an hour for
the amplifier to actually turn off. This is nothing to be
worried about, as the amp will be in low idle mode
which uses very little power (less than 1/2 Watt).
To prevent accidental damage to your subwoofer
from overdriving the system, the subwoofer features
an internal overload protection circuit, which will
turn the subwoofer off or down when overdriven or
overheated and will then resume normal operation
after a few minutes.
The appropriate voltage for your unit is indicated here
100–120V / 220–240V
Loading ...
Loading ...
Loading ...