Loading ...
Loading ...
Loading ...
14
22. OPERATION (CONT’D)
REMOTE CONTROL:
The power pack can also be operated using the optional ACR2 remote control.
When a button is pressed on the remote control, it sends a coded signal to the receiver (factory installed on the
power pack), indicating which function to activate.
¤ : Activates/deactivates delay-off.
- : Decreases blower motor speed until turned OFF (4 to 3, 3 to 2, 2 to 1 and 1 to OFF).
+ : Turns blower motor ON and increases speed (OFF to 1, 1 to 2, 2 to 3, 3 to 4).
: Turns ON/OFF the lamps.
1 : LED indicator (lights up blue when signal is transmitted to power pack).
NOTE: For more information, refer to the instructions included with the remote control.
Install the battery.
Before it can be used, the remote control has to be linked to the power pack following the procedure below.
L
INKING PROCEDURE (to a specific power pack):
1- Turn lights and blower off.
2- Press and hold the remote control
¤
button for 3 seconds (the LED indicator lights up).
3- Press and hold power pack button A for 3 seconds to confirm link. Lighting LED indicators 1 and 3 will then blink 3 times as a completion
feedback. Linking procedure needs to be confirmed within 30 seconds, otherwise it will be cancelled.
NOTES: 1. Pressing power pack button A for 3 seconds will not enter the linking mode. The linking mode can only be activated from the
remote control
¤
button.
2. Since the code is randomly assigned, it may be necessary to repeat the procedure in apartments or condos where many
products controlled by a remote control are close to each other.
U
NLINKING PROCEDURE:
1- Turn lights and blower off.
2- Press and hold power pack button E for 10 seconds. Lighting LED indicator 2 will then blink 3 times as a completion feedback.
HC0070
-
+
¤
1
Loading ...
Loading ...
Loading ...