Loading ...
Loading ...
Loading ...
13
– When the machine is not in use.
IMPORTANT! Always remember that an incorrectly used
chain saw may disturb others and have a serious impact on
the environment.
To respect people and the environment:
• Avoid using the machine in environments or at times of the
day when it may disturb others.
• Scrupulously comply with local regulations and provisions
for the disposal of waste materials after sawing.
• Scrupulously comply with local regulations and provisions
for the disposal of oils, damaged parts or any elements
which have a strong impact on the environment.
• A certain amount of chain lubricating oil is released into
the environment when the machine is running, so only use
biodegradable oils made specically for this use.
• To avoid the risk of re, do not leave the machine with the
motor hot on leaves or dry grass.
mWARNING! It takes specic training to use the machine
for felling and delimbing.
Checks During Work
• Checking the chain tension
The chain tends to stretch gradually as you work, so you need
to check its tension frequently.
IMPORTANT! During the rst period of use (or after replacing
the chain), the chain tension must be checked more frequently
due to settling of the chain.
mWARNING! Never work with the chain loose, as it can
be hazardous if the chain slips out of its guide.
To adjust the chain tension, follow the instructions in
“Adjust Chain Tension” on pages 10.
• Checking the oil delivery
IMPORTANT! Never use the machine without lubrication! You
can check the oil level in the tank through the transparent
gauge. Make sure you ll up the oil tank every time you use
the machine. For best results, use only a good quality bar and
chain oil designed specically for use with chain saws.
mWARNING! Make sure the bar and the chain are in
place when you check the oil delivery.
Start the motor and check if the chain oil is delivered as shown
below (Fig. 9).
Proper Cutting Stance
• Weight should be balanced with both feet on
solid ground.
• Keep your left arm and elbow locked in a "straight arm"
position to withstand any kickback force (Fig. 10).
• Your body should always be to the left of the chain line.
Basic Cutting Procedures
mWARNING! This unit is designed for trimming branches
and limbs up to recommended 8.5 in. (21.6 cm), not to exceed
a max. cut of 9.5 in. (24.1 cm) in diameter depending on type
of wood. Practice cutting a few small limbs using the following
technique to get the “feel” of using the saw before you begin a
major sawing operation.
• Take the proper stance in front of the wood with the saw
turned o (Fig. 10).
• Squeeze the trigger switch and let the chain accelerate to
full speed before entering the cut.
Fig. 9
Fig. 10
Chain line
Straight arm
Loading ...
Loading ...
Loading ...