Loading ...
Loading ...
Loading ...
6
INSTALLING THE ANTI TIP DEVICE
FOR FREESTANDING INSTALLATIONS
!
CAUTION
NOTE
Floor Mount Installation
The anti-tip bracket is to be located on the oor in the left or
right rear corner of the freezer as shown in Figure 7.
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the freezer. Slide it into
place, being careful not to damage the oor, leaving 1" (2.5
cm) of clearance from the rear wall to allow room for the
anti-tip bracket.
2) Raise the rear leveling legs approximately
1
⁄4" (6 mm) to
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the freezer is in the desired location, then
mark on the oor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the oor marking the front corner
of the cabinet, excluding the door. Slide the freezer out of
the way. From the temporary line extend the sidewall line
back 21
1
⁄2" (54.6 cm) as shown in Figure 8.
4) Align the anti-tip bracket to the marks on the oor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
1
⁄2" (54.6 cm) line (Rear of cabinet
line).
5) Fasten the anti-tip bracket to the oor using the supplied
screw. (See Figure 8).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
!
WARNING
• ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
• INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
• FOLLOW THE INSTRUC-
TIONS BELOW
Any nished ooring should be protected with appropriate
material to avoid damage when moving the unit.
If installing on a concrete oor, concrete fasteners are
required, (not included with the anti-tip kit).
Anti-Tip Device
!
WARNING
If your freezer is not located under a counter top (free
standing), you must use an anti-tip device installed as
per these instructions. If the freezer is removed from
its location for any reason, make sure that the device
is properly engaged with the anti-tip bracket when
you push the freezer back into the original location. If
the device is not properly engaged, there is a risk of
the freezer tipping over, with the potential for property
damage or personal injury.
Bottom View of
Freezer
Anti-Tip
Bracket
Leveling Leg
Front of cabinet
21
1
⁄2"
(54.6 cm)
Figure 7
Loading ...
Loading ...
Loading ...