Loading ...
Loading ...
Loading ...
10
USING YOUR ELECTRONIC CONTROL
Starting your freezer
Plug the freezer power cord into a wall outlet. Your freezer
will begin cooling after power is applied.
If your freezer does not start, check that the freezer is
turned on and the set temperature is cold enough.
Turning your freezer ON or OFF
If the freezer is on, the freezer temperature will be shown
on the display. To turn the freezer off, press and hold the
"ON/OFF" button for three (3) seconds. "OFF" will appear
on the display.
If the freezer is not on, "OFF" will be shown on the display.
To turn the freezer on, press and hold the "ON/OFF" but-
ton for three (3) seconds. The freezer temperature will be
shown on the display.
Set temperature
To set the freezer temperature, press and hold the "SET"
button. When the "SET" button is pressed, the display will
show the set temperature. While holding the "SET" button,
press the "WARMER" or "COLDER" buttons to adjust set
temperature.
Freezer operation
The available temperature range of the freezer is -10°F
(-23°C) to 10°F (-12°C).
It may take up to 24 hours for your freezer to reach desired
temperature. This will depend on amount of content loaded
and number of door opening and closings.
For best results allow freezer to "pull down" to desired set
temperature before loading. Once contents are loaded,
allow at least 48 hours for temperature to stabilize before
making any adjustments to the set temperature.
Set
Colder Warmer
ON/OFF
Press and Hold Press and Hold
Alarm
F
Figure 12
close-up of
control
• Temperature Sensor Fault: If the control-
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1"
will ash on the display panel and the Alarm LED located
at the top left of the display below the word "Alarm" will be
illuminated. Please call AGA MARVEL Customer Service or
your dealer if this error code is displayed.
• High and Low Temperature Alarm: If the
storage compartment temperature deviates
excessively from the set-point temperature, the
alarm will sound in (1) second intervals. The
display panel will ash either "Hi" or "Lo" de-
pending upon the condition and the Alarm LED
light at the top left of the display below the word
"Alarm" will be illuminated. The alarm will remain active
until the condition is corrected.
Alarms
Your electronic control will monitor freezer function and
alert you with a series of audible and visual alarms.
• Door Ajar Alarm: If the door has been left
open for over ve (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will ash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. This will stop as soon as the door is closed.
Figure 13
Loading ...
Loading ...
Loading ...