Loading ...
Loading ...
Loading ...
injury or damage to the tableware.
1. Release the latches on both the right and left tracks of the upper rack by turning them toward the outside (illustration A).
2. Pull out the rack completely. (illustration B).
3. Place the rack into the track again at the desired height (illustration C).
4. Push the latches back into the correct position.
How To Use The Lower Rack
We recommend that you place large items which are most difficult to clean into the lower rack: pots, pans, lids, serving dishes, and bowls, as shown in the figure
below.
It is preferable to place serving dishes and lids on the side of the racks in order to avoid blocking the rotation of the top spray arm.
Pots, serving bowls, etc, must always be placed top down. Deep pots should be slanted to allow water to flow out.
The bottom rack features fold-down tine rows so that larger or more pots and pans can be loaded.
Silverware Basket
Silverware should be placed in the silverware basket with handles at the bottom: if the rack has side baskets, the spoon should be loaded individually into the
appropriate slots, especially long utensils should be placed in the horizontal position at the front of the upper rack.
Caring And Maintenance
To clean the control panel use a lightly dampened cloth then dry thoroughly. To clean the exterior use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect against freezing
If your dishwasher is to be left in an unheated place during the winter, ask a service technician to:
1. Cut off electrical power to the dishwasher. Remove fuses or tip circuit breaker.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve. (Use a pan to catch the water.)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the plastic sump cover in the tub at the bottom and use a sponge to soak up water in the rubber boot.
Cleaning The Spray Arms
It is necessary to clean the spray arms regularly or hard water chemicals will clog the spray arm jets and bearings. To remove the spray arm, pull the nut out by
hand in an upward direction. Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them after rinsing them thoroughly.
Filtering System
For your convenience, we have placed the drain pump and filtering system within easy reach inside the tub. There are three components of the filtering system: the
coarse filter, the fine filter, and the main filter.
1. Coarse Filter
Larger items, such as pieces of bone or glass, that could clog the drain are trapped in the coarse filter. To remove an item caught in this filter, gently turn the top of
the Coarse filter in a counter-clockwise direction and lift it out.
2. Fine Filter
This filter holds soil and food residue in the sump area and prevents it from being re-deposited on the dishes during a cycle.
3. Main Filter
Food and soil particles trapped by this filter are pulverized by a special jet on the lower spray arm and washed down the drain.
Cleaning The Filter assembly
Turn the Coarse filter in a counter-clockwise direction.
1. Lift the Coarse filter (b) together with the Fine Filter(a)
2. Separate the Fine filter by lifting it out from the Course Filter (b).
3. Lift out the Main filter (c).
To replace the filter assembly follow the same steps in reverse. For best performance and results, the filter assembly must be cleaned. The dishwasher must never
be used without the filters. Improper replacement of the filter may reduce the performance level of the appliance and damaged dishes and utensils.
WARNING – Never run the dishwasher without the filters in place.
Cleaning The Door
Loading ...
Loading ...
Loading ...