Loading ...
1
Important Safety Instructions
Please save these instructions.
This manual contains important safety, installation, and operating instructions for the charge
controller. The following symbols are used throughout the manual to indicate potentially
dangerous conditions or important safety information.
WARNING: Indicates a potentially dangerous condition. Use extreme caution when
performing this task.
CAUTION: Indicates a critical procedure for safe and proper operation of the controller
NOTE: Indicates a procedure or function that is important to the safe and proper operation
of the controller.
General Safety Information
• Read all of the instructions and cautions
in the manual before beginning the
installation.
• There are no serviceable parts for this
controller. Do NOT disassemble or
attempt to repair the controller.
• Do NOT allow water to enter the
controller.
• Make sure all connections going into and
from the controller are tight.
Battery Safety
• Use only sealed lead-acid, flooded, or gel
batteries which must be deep cycle.
• Explosive battery gases may be present
while charging. Be certain there is
enough ventilation to release the gases.
• Be careful when working with large lead
acid batteries. Wear eye protection and
have fresh water available in case there
is contact with the battery acid.
• Carefully read battery manuals before
operation.
• Do NOT let the positive (+) and negative
(-) terminals of the battery touch each
other.
• Recycle battery when it is replaced.
• Over-charging and excessive gas
precipitation may damage the battery
plates and activate material shedding on
them. Too high of an equalizing charge
or too long of one may cause damage.
Please carefully review the specific
requirements of the battery used in the
system.
• Equalization is carried out only for non-
sealed / vented/ flooded / wet cell lead
acid batteries.
• Do NOT equalize sealed / VRLA type
AGM / Gel cell batteries UNLESS
permitted by battery manufacturer.
Loading ...
Loading ...
Loading ...