Loading ...
Loading ...
Loading ...
7
3. Place the container lid on the metal container and lock it
using the seal clips (Figs. 4 – 5).
Fig. 5
Metal
container
Container lid
assembly
Seal clip
Fitting the Suction Hose and Tube
1. Connect the suction hose to the metal container by
screwing the rotatable plastic end piece of the suction
hose (the end with the printed symbol) into the hose
connection securely (Fig. 6).
NOTE: When assembling/detaching the suction hose, hold
the black plastic end piece, not the metal suction hose.
Twisting or bending the hose could damage it (Fig. 6).
2. Insert the suction tube into the rigid end piece of the
suction hose (Fig. 7).
Operation
Switching ON/OFF
Do not switch on the ash vac until it has been completely
assembled. Before switching on the unit, always check the
appliance cord and the extension cord for signs of damage.
Use only intact cords.
mWARNING! Damaged cords pose a severe risk of injury.
Replace damaged cords immediately.
1. Connect the power cord into a working 120 V 60 Hz outlet.
NOTE: The equipment is tted with a safety stop switch,
which allows for operation only when the pleated lter and
wire lter basket are installed correctly.
2. If using an extension cord, make a knot with the two cords
like indicated by Table 1 on page 3.
3. To switch the unit on, set the On/O switch to position "–"
(Fig. 8).
4. To switch the unit o, set the On/O switch to position "o"
(Fig. 8).
Fig. 4
Metal
container
Container lid
assembly
Fig. 6
Suction hose
Hose
connection
The printed symbol
Plastic end piece
Fig. 7
Suction tube
Rigid end piece
Loading ...
Loading ...
Loading ...