Loading ...
Loading ...
Loading ...
49-7782-1 5
ENGLISH
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
BUTTONS
A
Display
B. Warning Light
Condensed water may accumulate in the unit. If the
internal tank becomes full, the warning light will light
up and the unit will not operate until the unit has been
drained.
C. Power Control
The power control turns the unit on and off.
D. Mode Control
The mode control has three settings: COOL,
DEHUMIDIFY, and FAN. The settings are adjusted with
Mode Control button. A light will indicate which setting is
currently being used.
Cooling Mode.
When cool mode is selected, the indicator light turns blue.
During the cooling mode the air is cooled and hot air
is exhausted to the outside through the exhaust tube.
Adjust fan speed and air temperature to suite your desired
comfort level. NOTE: The air exchange hoses must vent
outside the room when using cool mode.
Dehumidify Mode.
When dehumidify mode is selected, the indicator light
turns yellow. Air is dehumidified as it passes through
the unit, without being in full cooling mode. If room
temperature is higher than 77 degrees Fahrenheit, fan
speed can be adjusted; otherwise fan speed is fixed to
“Low”. NOTE: If the unit is to be used as a dehumidifier,
do not connect the exhaust hose let the warm air return
to the room. Continuous drainage is then necessary.
Fan Mode
When fan mode is selected the indicator light will shine
green. Air is circulated throughout the room with no
cooling. NOTE: Unit does not need to be vented in Fan
mode.
E. Fan Speed Control
Select between multiple fan speeds. Number of fan
speeds vary by model.
Hold the FAN button for 3 seconds, the fan will continue
running even when the compressor stops due to the
temperature being reached.
F. Timer
Auto Turn Off:
With machine in running mode, press timer button to
select number of hours you would like the unit to run in air
conditioning mode until it automatically shuts off.
Auto Turn On:
With machine in stand by mode, press timer button to
select number of hours until you would like the unit to
automatically start running in air conditioning mode.
F. Timer/Temp Set Controls
• Used for adjusting the timer and thermostat.
• The default display is room temperature.
• In cooling mode when ޔ or ޕ button is pressed, the set
temperature is displayed and may be adjusted. After 15
seconds the display will revert back to room temperature.
Temperature is only adjustable in cool mode. The time is
adjustable between 1-24 hours.
NOTE: By pressing both ޔ and ޕ buttons at the same
time, the display will toggle between Celsius and
Fahrenheit. The temperature cannot be adjusted in the
fan or dehumidification modes.
CONTROL PANEL
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
A
B
C
D
E
F
G
Hold 3 Sec for
Constant Cool
CONSTANT
COOL
COOL
DEHUM
FAN
LOW
HIGH
Loading ...
Loading ...
Loading ...