Loading ...
Loading ...
Loading ...
7
Side-by-side models
Refer to the side diagram for the following steps. You will be
working inside the freezer compartment.
1. Remove the screw from the ice maker wiring cover and
remove the cover.
2. Refer to DETAIL A, and with a pair of pliers, break away the
tabs from the wiring cover and discard them.
3. Insert the blade of a small screwdriver under the edge of the
round hole plug for the ll tube, (located at the back of the
freezer liner), and pry it out. You can discard the plug.
Refer to the side diagram for the following steps. You will be
working on the outside at the rear of the cabinet.
1. In the upper right corner of the cabinet, peel o the label that
is over the ll tube hole.
2. Pull the foam insert out of the ll tube hole and discard it.
Refer to the side diagram for the following steps.
1. Locate the ll tube and the round foam gasket from the ice
maker kit (the gasket may already be installed on the ll
tube). If not already done, slide the gasket over the end of the
ll tube.
2. Insert the ll tube through the hole in the rear of the
refrigerator with the spout facing down, and secure it with two
1/2" hex-head sheet metal screws.
Insert pin
into hole
Hole
Pin
Hole cover
Tab
Slot Screw
Insert tab
into slot
Wiring
harness
Wiring
cover
Ice maker wiring cover
Break o and discard
DETAIL A
Label
Remove
this label
for Ice
Maker
installation
Foam insert
Removing the label and foam plug
1/2" hex-
head sheet-
metal screws
Spout
Foam gasket
Fill tube
Spout
Installing the ll tube/gasket
Loading ...
Loading ...
Loading ...