Loading ...
Loading ...
Loading ...
20
Starting the Ice Maker
1. IMPORTANT: Make sure freezer lights are on and freezer
door switch remains open when performing this step.
Manually rotate ejector ngers 60 degrees towards a
vertical orientation. To avoid damaging ice maker, ejector
ngers should only be rotated in a clockwise direction (see
illustration).
2. Wash out the ice bucket, and then slide it under the ice maker
(see the side diagram) as far as it will go. The ice bucket will
be sitting on top of the freezer shelf.
IMPORTANT: On top-mount models without a full-width
freezer shelf, you will need to place the ice bucket on top of
the inverted ice tray shelf. First, position the ice tray shelf face
down so that the shorter side is alongside the freezer wall
(see DETAIL A). Then insert the tabs on the shorter side of the
shelf into the slots on the edge of the freezer oor. This will
hold the shelf in position. Next, place the ice bucket on top
of the inverted ice tray shelf and slide it under the ice maker
(see side diagram). The ice maker will not function properly if
the ice bucket is placed directly on the freezer oor.
3. Place the items back into the freezer compartment.
4. Lower the arm on the ice maker (see the side diagram) to its
“on” position, and close the freezer door. The ice maker will
begin to make ice within 24 hours.
NOTE: It usually takes approximately 24 hours for the ice
maker to begin producing ice. Once ice is available, you may
notice that it has an “off taste.” If this happens, make two or
three batches of ice and discard them. After that, the “off-
taste” should be gone. If you have any problems, refer to
“Troubleshooting” section.
This completes the installation of your Ice Maker.
Installing the ice bucket
Slots
Tabs
DETAIL A
Turning the ice maker on
On
O
Lower arm to start it
Raise arm to stop ice
Before After
Loading ...
Loading ...
Loading ...