Loading ...
Loading ...
3 / 4
Pair the lock with your smart home system
window
If you wish to unlock
the window, you can
slide it up for more
convenient access
to the programming
buttons while the
cover is installed.
To unlock the
window, remove
the security screw.
The window
on the interior
cover is locked
by default to
prevent someone
from tampering
with your lock's
settings.
Important Information about the interior cover
Cover Installation:
Install cover.
Note: You may need to
rotate the turnpiece to align
with the turnpiece shaft.
turnpiece
shaft
Install screws.
a
b
Install the interior cover
Initiate the pairing process through
your smart home system (either
through your smart home app, at your
panel, or at your controller or hub).
Refer to your smart home system
instructions for more information.
When prompted by your smart home system
to initiate pairing at the lock, press button
“A” on the lock interior four times.
If successful, re-name the lock in your system (if applicable).
If unsuccessful, press button “B” nine times.
Perform steps 8A8C again.
If still unsuccessful, follow your smart home system's
instructions to remove (exclude/unpair) the lock from
any other network. Then perform steps 8A8C again.
A B C
D
button “A” button “B”
Note: The interior cover and
screws must be removed
for battery pack access.
actual
size
Conirm the lock status
Perform the door handing process
6
7
8
9
The Status LED blinks every six seconds to communicate
whether the door is locked or unlocked.
If the Status LED is displaying the
wrong lock status, lip switch #4.
A B
Amber:
Locked
Green:
Unlocked
Switch #4
This step will teach the lock the orientation of your door and is crucial for lock operation.
A B C D
Install 4 AA batteries
in the battery pack.
Ensure correct polarity.
For best results, use new,
non-rechargeable Alkaline
batteries only.
Make sure the door is open. Insert the battery pack
while PRESSING AND HOLDING the Program button.
Keep pressing the button for three seconds after the
battery pack is installed, then release the button.
The Status LED will lash red and
green, and the lock will beep.
Press and release the Program
button again.
The latch bolt will retract and extend on its own
to learn the orientation of the door. Did the
Status LED turn green or red?
If the bolt does not move, make sure
the batteries are installed correctly,
and perform steps 6A6D again.
status LED
Metal
contacts
at bottom,
facing out.
BALDWIN ESTATE DEADBOLTS:
If your latch bolt is to the RIGHT of your interior assembly, and the
Status LED is solid red after door handing, press and release the
Program button again. The door handing process will restart.
If you are unsure if your lock is Baldwin Estate, see
chart on page 1 or compatible deadbolt list online.
Red Status LED
Green: Door handing
successful. Continue
to step 7.
Red: See “Red Status
LED” below.
Right
OTHER DEADBOLTS:
If the Status LED is solid red after door handing, make sure
the batteries are installed correctly and the lock interior
is correctly installed. Perform steps 6A6D again.
Loading ...