Loading ...
Loading ...
Loading ...
10
Close the lid (b).
Press the ON OFF button (r) to turn on the coffee maker and then press BREW (k) to start the cycle. The
BREW button light will come on to show that the coffee maker has started the brew cycle. The machine
will beep once. Fig. 11.
Once the cycle has finished, the machine beeps 3 times and the keep warm function switches on
automatically for a duration of 4 hours. At the end of the keep warm time, your machine beeps 3 times and
the BREW button (k) goes out.
Note:
- The amount of coffee in the carafe at the end of the cycle is less than the amount of water poured into the
tank because about 10% is absorbed by the ground coffee and the filter.
- There is an overflow hole on the back of the water tank. If you add too much water, it will leak out of this hole.
- Clean the permanent filter between each use or use a new paper filter.
CAUTION:
- To avoid any overflow, the carafe must be properly positioned on the warming plate of the
coffee maker, otherwise it could cause hot water or hot coffee to overflow.
- The coffee maker becomes very hot during the brew cycle. Please handle with care.
6. OTHER FEATURES
6a – AUTO START FUNCTION (AUTO)
Programming the auto-start settings.
Your appliance is equipped with auto-start program.
Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
Press the ON OFF button to turn the coffee maker on and press the AUTO button to set the time. The
AUTO icon will appear on the display. Figs 12-13-14.
Set the time by pressing the HR button (m) to set the hour and the MIN button (n) to set the minutes.
The time set is automatically set after about five seconds.
Starting a auto-on function when time has already been set.
- See the section MAKING COFFEE.
- Press AUTO.
To cancel the delayed start, press AUTO once.
6b – REGULAR OR BOLD
The BOLD function allows you to adjust the coffee intensity.
Press the BOLD (o) button to select the strength of your coffee. Fig. 15.
The BOLD button lights up (o).
The function is stored in the memory for subsequent cycles.
To cancel the BOLD function, press the BOLD button again.
6c – 1 - 4 CUPS
This function is specially designed for making small amounts of coffee, with optimal aroma and flavor.
To activate this function, press the 1 - 4 CUPS button (p) before starting the cycle. Fig. 16.
The 1 - 4 CUPS button lights up.
To cancel the 1 - 4 cups function, press the 1 - 4 CUPS button again.
7. CLEANING
To remove the used coffee grounds, remove the filter and the filter holder from the coffee maker. Fig 17a.
and Fig 18a.
Loading ...
Loading ...
Loading ...