Loading ...
Loading ...
Loading ...
ENGLISH
9
Fig. Q
22
21
• Insert the 3/4 inch (19mm) end of the bulk line into
the hole
23
in the spool adjacent to the slot as shown
in Fig. R. Make sure the line is pulled tight against the
spool as shown in Fig.S.
Fig. R
24 23
• Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross (Fig. S).
• When the wound cutting line reaches the recesses
24
,
cut the line. (Fig. R).
• Fit the spool onto the trimmer as described in
“REPLACING THE SPOOL”.
CAUTION: Before you begin trimming, only use the
appropriate type of cutting line.
Fig. S
Troubleshooting
Trimmer Runs Slowly
1. Unplug thetrimmer.
2. Check that the spool housing can rotate freely. Carefully
clean it ifnecessary.
3. Check that the cutting line does not protrude more
than approximately 5-3/8 inches (136mm) from the
spool. If it does, cut it off so that it just reaches the line
trimmingblade.
Automatic Line Feed Does Not Work
1. Unplug thetrimmer.
2. Remove the spoolcap.
3. Pull the cutting line until it protrudes approximately
5-3/8 inches (136mm) from the spool. If insufficient
cutting line is left on the spool, install a new spool of
cutting line.
4. Ensure that the line is not crisscrossed on the spool as
detailed in Fig. S. If it is, unwind the cutting line, then
wind it back on the spool neatly so that the lines do
notcross.
5. Ensure the beginning of the cutting line is pulled tight
against the spool as shown in Fig.S.
6. Align the tabs on the spool cap with the cut outs in
thehousing.
7. Push the spool cap onto the housing until it snaps
securely intoplace.
8. If the cutting line protrudes beyond the trimming
blade, cut it off so that it just reaches the blade. If the
automatic line feed still does not work or the spool is
jammed, try the following suggestions:
9. Carefully clean the spool andhousing.
10. Remove the spool and check if the lever in the spool
housing can movefreely.
11. Remove the spool and unwind the cutting line,
then wind it on neatly again. Replace the spool into
thehousing.
Repairs
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a BLACK+DECKER
factory service center or a BLACK+DECKER authorized
service center. Always use identical replacementparts.
Register Online
Thank you for your purchase. Register your product nowfor:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with yourproduct.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
ofpurchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
SafetyAct.
Register online at www.blackanddecker.com
Loading ...
Loading ...
Loading ...