Loading ...
Loading ...
Loading ...
66 -
The hob does not operate.
The hob does not cut off
The hob stops automatically
Frequency of on/off operations
for cooking zones
The hob does not operate or cer-
tain zones dont work
H display, residual heat
indicator, blinking
A big spill or object covers at least two buttons, for
at least 10 seconds. Clean up the spill or remove the
object.
The control panel is locked. Press the Locking
button to release.
The control panel is locked. Press the Locking
button to release. Refer to the section, Operating
time page 61.
A spill covers at least two buttons for more than
10 seconds; the hob switches to safety, and an audible
beep sounds so long as the buttons are covered. Clean
up the spill or remove the object.
The cooking zones stop automatically if they are
left on for too long. Refer to the section, Operating
time page 61.
The on-off cycles vary according to the required
heat level:
- low level: short operating time,
- high level: long operating time.
The shunts are not positioned correctly on the
terminal board. Have a check made that the
connection is done in compliance with the
recommendations, page 50 & 51.
The electronic temperature is too high. A technician
should verify the fitting in compliance with the
recommendations, page 52 & 53.
PROBLEMS AND SOLUTIONS
Loading ...
Loading ...