Loading ...
Loading ...
Loading ...
15
For frozen food, refer to the storage time written on the food packaging. This storage
time is achieved whenever the setting respects the reference temperatures of the
compartment (one-star -6°C, two stars -12°C, three stars -18°C)
ENERGY SAVING
For better energy saving we suggest:
Installing the appliance away from heat sources and not exposed to direct sunlight and
in a well-ventilated room.
Avoid putting hot food into the refrigerator to avoid increasing the internal temperature
and therefore causing continuous functionalizing of the compressor.
Do not excessively stuff foods so as to ensure proper air circulation.
Defrost the appliance in case there is ice to facilitate the transfer of cold.
In case of absence of electrical energy, it is advisable to keep the refrigerator door
closed.
Open or keep the doors of the appliance open as little as possible.
Avoid adjusting the setting to temperatures too cold.
Remove dust present on the rear of the appliance.
TAKE CARE
Defrosting
Defrost twice a year or when a frost layer of around 7 mm (1/4”) has formed.
Alternatively you may switch off the freezer at the socket outlet and pull out the mains plug. Extract
the water conduit and put in a water container.
6 hours before the defrosting, please set the thermostat knob at “MAX” position to make sure the
food is at the lowest temperature when you get it out. All food should be wrapped in several layers
of newspaper and stored in a cool place (e.g. fridge or larder). Remove the freezer basket. Leave the
lid open. Containers of warm water may be placed carefully in the freezer to speed up the
defrosting.
When defrosting has finished flow out defrost water which collects at the bottom of the freezer as
the below diagram and dry the interior thoroughly. Switch on the Fast Freeze and leave it on for
about three hours.
1. There is a water conduit at the bottom of the freezer, when defrosting, extract the rubber
cover, defrosted water will drip into the hole and flow out. (NOTES: Please keep the rubber
cover well during the defrosting and put it back after defrosting is done).
2. Extract the water conduit by 20-25mm until the water hole can be seen.
3. Twist the water conduit until the arrow points downward.
4. After defrosting is done, make sure there is no more water coming out before out the water
conduit in place and make the arrow point upward.
Loading ...
Loading ...
Loading ...