Loading ...
Loading ...
Loading ...
15
ATTENTION! The housing protection should never be cleaned with
abrasive and aggressive products.
ADVICE FOR USERS
- Putting the appliance at its maximum setting will not increase the
temperature faster.
- If you are out for several hours, consider lowering the temperature.
- If you have several appliances in one room, let them operate
together, so you have a more uniform temperature while optimizing power
consumption. This also applies to an empty room; where it is better to let
the appliance run at a lower setting, rather than turn it off completely.
TROUBLESHOOTING
The appliance is not heating: Check that the installation circuit-breakers
are engaged. Check the room air temperature. For models fitted with a
remote programmer, check it is in COMFORT mode.
The appliance is constantly heating: check the appliance is not in a
draught, or whether the temperature setting has been changed.
The surface of the appliance is very hot: It is normal that the convector
is hot when operating, it being understood that the surface temperature is
limited according to the current standard However, if you feel that your
appliance is still too hot, verify that the power is correct for the surface area
of your room (we recommend on average 100 W/m2) and the appliance is
not in a draught that would affect its setting.
CONTACTS
ATL International
Tél: (+33)146836001
58 avenue du Général Leclerc
92340 Bourg-la-Reine (FRANCE)
WARRANTY
KEEP THIS DOCUMENT IN A SAFE PLACE
(This certificate should only be produced if you are making a complaint)
- This guarantee is applicable for 7 years from the date of original purchase
and upgradable by online registration. Conditions apply.
- Our goods come with guarantees that cannot be excluded under the
Australia Consumer Low. You are entitled to a replacement or refund for a major
failure and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goodas repaired or replaced if the
goods fail to be of acceptable quality and failure does not amount to a major
failure.
Loading ...
Loading ...