Sun Joe CJ602E User Manual

Loading ...

Troubleshooting

Motor does not run

Chipping material is not

being pulled in

Blades cutting

ineciently

• Reverse the blades or replace with new

blades.

Problem Remedy

Possible Cause

• Power failure/unit not plugged into a

working receptacle.

• The overload protection has

responded.

• The hopper is opened.

• Check to make sure unit is plugged into a

working outlet. Make sure extension cord is

not damaged.

• Remove any chips and press the reset

button. Wait one minute before pressing the

ON/OFF switch to restart the unit.

• Check to make sure the hopper is secured

and the hopper locking knob is tightened.

• The material is jammed in the feed

inlet.

• The cutting blades are blocked.

• The discharge chute is blocked.

• Examine the cutting head and remove any

blocked material. Replace the hopper.

• Disconnect the power supply and open

the hopper. Open the blade cover. Remove

the blocked material and replace the blade

cover and hopper.

• Disconnect the power supply and open the

hopper. Open the plate of the discharge

chute to clear the blocked material.

Replace the plate and hopper.

• Blade edges are worn.

Only a company specialist may be able to correct faults that cannot be rectied with the aid of this table. Please call the

Snow Joe

+ Sun Joe

customer service center at 1-866-SNOWJOE (1-866-766-9563).

Loading ...

Sun Joe CJ602E Electric Wood Chipper 17:1 Reduction 15 Amp