Loading ...
Loading ...
3
13. This heater has hot and potentially sparking parts inside. Do not use the heater in
any areas where gasoline, paint, or any other flammable materials are used or
stored.
14. Place this heater near a wall outlet so an extension cord is not needed. If an
extension cord is necessary, the gauge of the cord must be at least 14AWG, and
the rating must be at least 1875-watts. Never use a smaller gauge cord with a
lower rating. Doing so may result in electric shock or fire.
15. Always disconnect power before performing any cleaning or maintenance.
16. When transporting or storing the heater, keep in a dry location that is free from
excessive vibration in order to avoid damage.
17. Use this heater only as described in the manual. Any other use that is not
recommended by the manufacturer may cause fire, electrical shock, and injury.
18. The flame effect is powered by a motor. It is normal for this motor to at least
make some noise as it slowly rotates to create the beautiful flame effect. Some
rooms with more or less furnishing may result in varying noise amplification.
19. Attach all four legs before plugging in and turning on heater. Failure to do so
could start a fire.
20. Only use this heater on a 120V AC 15-AMP grounded circuit. Never overload the
circuit. If the heater trips the circuit breaker, unplug all other appliances on the
same circuit before the next use. Avoid plugging other appliances into the same
circuit as the heater.
21. Every effort has been made to ensure packing materials are kept outside of the
plastic bag, which covers your heater in the box. There is a possibility that some
packing may have lodged into the heater vent. If you notice this upon close
inspection, please remove it. When turning on your heater for the first time it is
normal for the heater to emit a little “new heater” smell, which will quickly
dissipate.
22. The power cord supplied with the electric heater has three prongs, two flat blades
(live and neutral) and one round pin (ground). If a 3-slot receptacle is not
available, an adapter must be used. The adapter must be properly grounded to
the outlet box. Note: adapter is not included.
PREPERATION
• Remove all parts and hardware from the carton and place them on a clean, soft,
and dry surface.
• Make sure all parts are dry, and that the power cord and plug are not damaged.
• Compare the contents with the parts list to make sure nothing is missing.
• Dispose of all packaging materials properly.
• Please recycle whenever possible.
Loading ...
Loading ...
Loading ...