Loading ...
Loading ...
Loading ...
DOS
It is essential that good hygiene practices are observed in the use and maintenance of your Perfect Prep machine.
✔
Ensure your hands and all surfaces that come in to contact with the machine and its components (including filter) are clean.
✔
This product is intended for use with Tommee Tippee Closer to Nature Perfect Prep Water Filters which are available
from all Perfect Prep machine stockists.
USE OF ANY OTHER WATER FILTER WITH THIS PRODUCT COULD PUT YOUR CHILD’S HEALTH AT RISK.
✔
Before first use clean the unit following the set up steps provided in this leaflet.
✔
Keep the unit away from direct sunlight.
✔
Only use cold tap water during regular use.
✔
Keep the outside of the unit clean.
✔
For your childs safety always check the food temperature before feeding on a sensitive part of your skin.
✔
Be careful when handling boiling water.
✔
Always adjust the height of the bottle stand so the bottle neck is close to the dispensing spout. This is to maintain the
temperature of the water and to avoid any splashes.
✔
Keep well clear of the dispensing spout as the unit produces steam and very hot water.
DON’TS
✘
Do not allow the water tank to be contaminated. The inside of the unit should only be cleaned by following the cleaning
process steps provided in this leaflet.
✘
Do not clean with solvents or harsh chemicals.
✘
The appliance is intended for use in a kitchen. It is not suitable for use in a nursery.
✘
Do not use hot water other than during cleaning cycles. If water in the tank is higher than 25°C, the unit will not operate.
If this happens, either change the water or allow the water to cool and restart.
✘
Do not pour boiling water over the water filter.
✘
When topping up the hopper, do not fill beyond the max line.
✘
Be careful not to spill any water on the outside of the machine.
✘
Do not remove the back panel from the unit.
DO’S AND DON’TS
A red warning light will illuminate when the unit requires descaling soon.
If the light flashes, you should descale immediately
Remove the filter.
Fill the water tank with 0.5 litres of clear white vinegar (food grade).
Place a suitable container under the spout.
Press the descale button for 2 seconds. The system will now run a descale process.
During this process the red descale light will continue to flash.
At the end of the descale process a beep will sound and the descale light will switch off.
The red cleaning mode light will now flash.
Follow the SET UP steps 1-15 (no need to use step 9a or 12 if refitting current filter)
DESCALING
The descaling process will remove deposits of calcium and other minerals in the system that may affect its
performance.
1
2
3
4
5
6
7
0423708
INFORMATION ON THE DISPOSAL FOR WASTE ELECTRICAL & ELECTRONIC EQUIPMENT (WEEE)
This symbol on the products and accompanying documents means that used electrical and electronic products should not be mixed with general household waste.
For proper disposal for treatment, recovery and recycling, please take these products to designated collection points where they will be accepted on a free of charge basis. In some countries you may be able to return your products to your
local retailer upon the purchase of a new product. Disposing of this product correctly will help you save valuable resources and prevent any possible effects on human health and the environment, which could otherwise arise from
inappropriate waste handling. Please contact your local authority for further details of your nearest collection point for WEEE. Penalties may be applicable for the incorrect disposal of this product in accordance with national legislation.
The product is fitted with a BS 1363 mains plug containing a 13A fuse. If it ever becomes necessary to replace the fuse, only use fuses that are marked BS 1362, and rated at 13A. In the unlikely event that this plug is not suitable for the
sockets in your home, it should be removed and a suitable plug fitted as follows: The wires of the mains lead are coloured in accordance with the following code:
GREEN AND YELLOW – EARTH
BLUE – NEUTRAL
BROWN – LIVE
As these colours may not correspond with the coloured markings sometimes used to identify the terminals in the plug, connect as follows. The wire coloured GREEN AND YELLOW must be connected to the terminal marked E or by the earth
symbol or coloured GREEN or GREEN AND YELLOW. The wire coloured BLUE must be connected to the terminal marked N or coloured BLACK.
The wire coloured BROWN must be connected to the terminal marked L or coloured RED. If
you are in any doubt about how to wire a plug or replace a fuse safely, consult a qualified electrician.
Jackel International Limited trading as Mayborn Group, Northumberland Business Park West, Cramlington Northumberland NE23 7RH, UK
Made in China