Loading ...
Loading ...
Check the water level and
regularly top up when necessary
with cold water. When filling the
tank with water, ensure the hopper
is in place.
Turn the dial to select the feed size
you require (4fl oz –11fl oz).
Position your sterilised bottle under
the spout. Adjust bottle stand if
necessary (bottle neck should sit
close to the spout).
Press the start/stop button.
A red light will flash and a volume
of hot water is dispensed into your
bottle.
1 2 3
USAGE
Before each use you must ensure that your water tank is above the minimum fill mark.
Always use cold water when filling the water tank, other than when cleaning.
11
12
Without removing the hopper from the machine and still holding the filter
by the top, place the filter in the hopper, ensuring it locks in to place.
Fill the hopper with cold water. Wait for the tank empty warning
light to go out.
Set the dial to 4oz with container
under the dispenser spout.
Press the start/stop button. A red
light will flash.
13 14
The appliance will dispense an
amount of hot water.
Press the start/stop button again.
A green light will flash and an amount
of water will be dispensed to finish
the cycle. Discard the contents of the
container. Fit the bottle stand.
Your machine is now ready to use.
• Remove the filter from the
packaging
• Remove sticker from the top of filter
• Fill a bowl with cold tap water
• Fully submerge the filter in the water
• Gently agitate until the bubbles stop
9a
9b
10
11
13 14 15
Press the filter volume reset button
for 2 seconds to clear the memory.
FILTER
VOLUME
RESET
Handling the filter
by the top only:
12
Loading ...
Loading ...
Loading ...