Loading ...
Loading ...
Loading ...
- 12 -
REMOTE CONTROL
RF REMOTE MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
door (A) in order to access the battery compartment. FIG. 2.
Remove the battery and replace with battery type A23 12V.
Negative end of battery should face the spring inside the remote.
Re-install battery door and recycle old battery.
RF REMOTE FEATURES:
The RF remote control is equipped with a magnet on the back for easy
storage. The remote may be placed on any magnetic surface such as a
refrigerator or the Zephyr remote holder, FIG. 1. The remote holder can
be inserted into a standard electrical outlet for easy storage. Note: The
remote holder does not charge the RF remote.
Maximum remote control communication distance is 15 feet from the hood.
REMOTE PAIRING: To create a unique link between your hood and remote control please follow these steps:
RF REMOTE FUNCTIONS:
FIG. 1
FIG. 2
Blower On / Speed Selection
Press to power on blower and cycle through all six blower speeds.
Blower On / Power Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
Lights On / Dim / Off
Switch lights On by pressing once, again to dim and again to switch Off.
Blower On/
Speed Selection
1
1
2
3
4
Blower On/
Power Off
2
10 Min Delay Off
3
Lights On/Dim/Off
4
By pressing , the blower and lights will enter Delay Off mode. The blower will
change to speed 1 and shut down after 10 minutes.
A
-
+
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compli-
ance could void the user’s authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer
or peripheral device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
1. With hood off, press and hold the “Lights” button on the hood until the lights button indicator blinks.
2. Press the “Blower On/ Power Off” button on the remote, the “Lights” button on the hood will stop blinking and the
synchronization is complete.
CLEAN FILTER REMINDER RESET:
Mesh Filter Clean Reminder: With hood off, press and hold the “Blower On/
Speed Selection” button and “Lights” button simultaneously.
Charcoal Filter Clean Reminder: With hood off, press and hold the “Delay
Off” button and “Lights” button simultaneously.
Clean Air On / Off
5
With hood off, press and simultaneously to power on the clean air function.
To power off the clean air function, press and simultaneously with hood off.
Loading ...
Loading ...
Loading ...