Loading ...
Loading ...
Loading ...
EN
DE
FR
ES
JP
IT
EN
DE
FR
ES
JP
IT
4 5
Shaving Off Fluff
1. Put the garment on a flat surface, such as an ironing
board. Make sure the surface has no wrinkles.
Otherwise, the garment may be damaged.
2. Turn the spacer to the desired level or remove it
completely (see the "Removing/Attaching the Spacer"
section of this manual).
• “Thick” is for large bobbles and coarse textiles; 5mm-
length distance from the cutting blades.
• “Thin” is for small lint/bobbles and fine textiles; 3mm-
length distance from the cutting blades.
• Removing the spacer is only for very fine lint; virtually
no spacing to the cutting blades.
3. Push the On/Off/Speed Switch to the required speed
level.
4. Guide the shaver foil lightly over the material. The fluff
and bobbles will be shaved off and collected in the
fluff collector.
5. To turn off the shaver, push the On/Off/Speed Switch
back to Speed Level 0.
Note:
• Empty the fluff collector regularly. The fluff collector
should never be more than 3/4 full. An overfilled
fluff collector will slow the cutting blades no matter
the amount of battery power left.
Removing/Attaching the Spacer
• To remove the spacer, hold the shaver with one hand,
grab the spacer, put your thumb on the edge of the
spacer, pull the spacer forward, and remove it.
Pull to open
Thick Thin
Regulator
• To attach the spacer, place it on the cutting head and
press it firmly. Make sure the two small tabs on the
spacer grip into the two recesses on the shaver.
Pull to open
Thick Thin
Regulator
• To protect the shaver foil, you should remove the
spacer and place the protective cap on the shaver foil
when not using the fabric shaver.
Loading ...
Loading ...
Loading ...