Loading ...
Loading ...
Loading ...
9
ENGLISH
(Original instructions)
Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
R
Do not expose the tool to rain or high humidit
Chain oil.
Moving direction of the chain
(Marked under teh sprocket cover)..
Rotate to adjust chain tension, clockwise tighten
the chain, Anti-clockwise to loose the chain.
Hold and operate the saw properly with both
hands.
Do not operate the saw using only one hand.
Contact of teh guide bar tip with any object
should be avoided! Tip contact may case the
guide bar to move suddenly upward and
backward, which may cause serious injury.
y.
Directive 2000/14/EC guaranteed sound power.
E
Caution: Do not over tighten. Tighten by
hand. Finger tight only.
Electrical safety
#
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Using an extension cable
u Always use an approved extension cable suitable for the
power input of this tool (see technical data). The extension
cable must be suitable for outdoor use and marked ac-
cordingly. Up to 30 m of HO7RN-F 2 X 1.5 mm² extension
cable can be used without loss of product performance.
Before use, inspect the extension cable for signs of
damage, wear and ageing. Replace the extension cable
if damaged or defective. When using a cable reel, always
unwind the cable completely.
Voltage drops
u Under certain power supply conditions this product may-
cause short-time voltage drops during start-up.
u Other equipment may be affected. For example, electri-
clights may temporarily reduce in brightness.
u Contact the supply authority, if necessary, to determine
that the impedance of the power supply is lower than
0.172/0.293 ohms. Disturbances are unlikely to occur
under this condition.
Guard against electric shock
u Prevent body contact with earthed or grounded surfaces
(e.g. metal railings, lamp-posts etc.). Electric safety can
be further improved by using a high-sensitivity (30 mA/
30mS) Residual Current Device (RCD).
:
Warning! The use of an RCD or other circuit
breaker unit does not release the operator
of your chainsaw from the safety instructions
and safe working practices given in this user
manual.
Features
1. On/off switch
2. Lock-off button
3. Front guard/chain brake assembly
4. Guide bar
5. Chain
6. Chain cover assembly
Wear non-silp safety footwear when using the
product.
Wear non-silp, heavy dutygloves when using this
product.
Wear eye, ear and head protectionwhen using
this product.
Remove plug from the mains immediately before
maintenance or if cable is damaged or cut.
Warning! Do not touch chain at the chip
ejection point.
Loading ...
Loading ...
Loading ...