Loading ...
Loading ...
Loading ...
10
ENGLISH
(Original instructions)
u Place the chainsaw onto a stable surface.
u Set the front guard/chain brake assembly (3) to the
u Rotate the chain adjust locking knob (7) counterclockwise
u Place the chain (5) over the guide bar (4) making sure that
the saw chain cutters on the upper part of the guide bar
u Guide the chain (5) around the guide bar (4) and pull it to
create a loop to one side at the rear end of the guide bar
(4).
u Guide the chain (5) around the drive sprocket (14), line up
the slot in the guide bar and the centre hole of the chain
Note: rotate chain tensioning wheel as necessary to line
centre hole with bolt (15).
Warning! Make sure that the front guard/chain brake assem-
u Place the chain cover assembly (6) onto the chainsaw.
u Make sure that the tab (17) on the chain cover assembly
E).
u Rotate the chain adjust locking knob (7) clockwise until
snug.
u Check the tension - see 'Checking the chain tension'
below.
uIf chain tension is loose - see 'Increasing the chain tension'
below.
Before use and after every 10 minutes of use, you must check
the chain tension.
u Disconnect the tool from the mains supply
u
tension is correct when the chain (5) snaps back after be-
ing pulled 3 mm away from the guide bar (4). There should
be no "sag" between the guide bar (4) and the chain (5)
u Loosen the chain adjust locking knob (7) counterclockwise
one half turn.
u Turn the chain tension adjustment wheel (8) clockwise
until slight resistance is felt.
u Check tension - see 'Checking the chain tension'.
u If satisfactory, re-tighten locking knob (7), or if
more tension is required, turn adjustment wheel (8). Then
re-tighten locking Knob (7).
Note: Do not over-tension the chain as this will lead to
excessive wear and will reduce the life of the guide bar and
the chain.
Note: When the chain is new, check the tension frequently
use because a new chain stretches slightly.
Use
W
Oiling the chain
arning! Let the tool work at its own pace. Do not overload.
u
recommended chain oil. You can see the oil level in the oil
u Periodically switch off and check the oil level indicator
(13); if it is less than a quarter full, disconnect your chain-
This chainsaw is equipped with an automatic oiling system
that keeps the saw chain and guide bar constantly lubricated.
We recommend that you use only BLACK+DECKER oil during
the lifetime of your chainsaw because mixtures of different oils
could lead to the oil becoming degraded, which can drastically
shorten the lifetime of the saw chain and create additional
risks.
7. Chain adjust locking knob
8. Chain tension adjustment wheel
9. Chain sheath
10. Power cord
11. Power cord retainer
12. Oil cap
13. Oil level indicator
Assembly
@
Warning! Always wear protective gloves when
working on your chainsaw.
@
Warning! Before performing any assembly
or maintenance on power tools, switch off and
disconnect from mains.
@
Warning! Remove the cable tie that attaches
the chain to the chainbar before assembly.
Never use waste oil, thick oil or very thin sewing machine
oil. These may damage your chainsaw .Only use the correct
grade of oil (cat. no. A6023-50).
u The chain saw will automatically feed oil to the chain dur
ing use.
Loading ...
Loading ...
Loading ...