Loading ...
Loading ...
Loading ...
6
In
on
Dismantle the transport on bolts
The transpo
on bolts are designed for clamping an -
vib
on components inside of the washing machine
Remove the back cover. 1.
2.
3.
4.
Remove the four bolts on the rear side and take out
the back cover.
Fill the holes le
by the bolts with blanking plugs.
Note:
the back cover, the convex
must face to outside, and you have to insert the
back cover from the two gaps as
Keep the transporta on bo stabili-
zers in a safe place for later use.
Before Use
re adjustable feet under the bo om of the washing machine. Before
use, th
There a
ey should be adjusted so that the machine is level. This will minimize
vibr
ons and thus noise during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment.Floor should be as stable and
1.
2.
3.
Adjus ng the feet and locking nut
inside,screw the bolts through the four holes on the board on to the tub firmly(Fig3).
and 4).Finally set the machine upright again.
2x
2x
1.
2.
3. 4.
shown in fig.5.
flat as possible.
Loading ...
Loading ...
Loading ...