Loading ...
Loading ...
Loading ...
6
BREW DRAIN
BREW
DESCALE
POWER
PUSH TO BREW
DRAIN BREWER
HEATING
AUTO OFF
ADD WATER
SECTION 1 Set-Up & First Brew
Setting Up Your Brewer
1. Unwrap the Power Cord and plug the
brewer into the mains socket. Remove all
pieces of packing tape.
2. Make sure the BREW/DRAIN Selector
Knob is set to BREW (fig. 1).
3. Place a large mug, 300 ml (10 oz), on
the Drip Tray Plate.
4. Remove the Water Reservoir from the
brewer by first removing the Water
Reservoir Lid (fig. 2), then lifting the
Water Reservoir straight up and away
from the brewer (may be tight). Rinse
with fresh water.
IMPORTANT: You cannot use your Keurig
®
brewer
until it has been set-up for its first use as set
forth below.
NOTE: If the brewer has been exposed to
temperatures below freezing, allow the brewer
at least two hours to reach room temperature
before brewing. A frozen or extremely cold
brewer will not operate.
5. Fill Water Reservoir with bottled or filtered
water. The water level should reach the line
just below the top edge of the clear
viewing area. Do not overfill.
6.
Replace the Water Reservoir on the brewer.
Replace the Water Reservoir Lid on the
Water Reservoir.
7. Press the POWER Button (fig. 3) on the
Control Panel. The green Power Light will
come on. NOTE: A K-Cup
®
pod should not be
used for this sequence
.
NOTE: If the Water Reservoir is empty or not
in place on the brewer, the blue ADD WATER
Light will come on. The BREW Button will
not work until water has been added to the
Water Reservoir and the Water Reservoir is
in place.
8.
The brewer will automatically fill with water
and then the water will be heated. This will
take less than 5 minutes. During the heating
period, the red HEATING Light will come on.
Once the water is heated, the red HEATING
Light will turn off and the selected brew size
will come on. NOTE: Do not lift Handle during
this heating period.
fig.
3
fig.
4
fig.
1
fig.
2
Loading ...
Loading ...
Loading ...