Loading ...
Loading ...
Loading ...
ENGLISH
4
• Do not insert pieces of metal, such as coins, hairpins and metal debris, or flammable materials, such as paper or
matches, into the product.
- Doing so may cause fire or result in electric shock. If foreign materials fall into the product, disconnect the power
cord and then contact the service center.
• Do not install the product by yourself. The product should be installed by a professional installation technician
specified by the retail store.
- Product installation by a non-professional installation technician is very dangerous and may cause personal injury.
• Do not install the product onto a wall that is close to sources of oil or oil mist.
- Otherwise, it may result in damage to the product and cause the product to fall.
CAUTION
Failure to observe these instructions may result in minor injury or damage to the product.
• Set to [Screen OFF & Backlight(Outdoor Mode)] when installing outdoors.
- Enable the [Outdoor Mode] to reduce the risk of the internal humidity and condensation.
- When operating in below zero temperature, the enclosure may not work for up to one hour to raise the internal
temperature of the enclosure.
• Ensure that the product is installed a certain distance (at least 100 mm (3.9 inches)) away from the wall for good
ventilation.
- Failure to do so may result in the deformation of the product or fire due to the increase in the internal temperature.
• When placing the product on a table or shelf, be careful not to place it on the edge.
- The product may fall, causing personal injury or damage to the product. Make sure to use a table or stand that fits
the product.
• Do not place the product close to sources of steam or oil, such as humidifiers and kitchen counters.
- This may result in electric shock or fire.
• Make sure the air vents are not blocked by a tablecloth or curtain.
- Failure to do so may result in the deformation of the product or fire due to the increase in the internal temperature.
• Do not install the product in an area with poor ventilation (e.g. on a bookshelf, in a closet, in separate outdoor
structures), and avoid placing on cushions or carpets.
- This could result in fire due to high internal temperature.
• Do not place the product on an unstable or vibrating surface such as a vibrating shelf or tilted surface.
- The product may fall or flip over and cause injury.
• Do not install the product in a place with electromagnetic interference.
• In addition, do not install it in close proximity to hot objects, such as lights.
• If you install the product in unusual locations that do not meet the general conditions, this may cause serious damage
to the product’s picture quality, life cycle or appearance. Please check with our service engineers before installing in
such locations.
- Unusual locations: Locations where much fine dust or oil mist is generated, locations where chemical substances
are used, locations where the temperature is too high or low and other locations where the product was not meant
to be used.
• A readily accessible disconnect device shall be incorporated external to the product.
• The components complied with the requirements of IEC 61643-series shall be installed internal or external to this
product.
Loading ...
Loading ...
Loading ...