Loading ...
Loading ...
Loading ...
9
2. Remove any broken cutting line, wind the remaining
line tight and re-insert the spool into the spool cover as
follows (Figs 14 – 16):
a. Wind the line tight enough so that it is all below the
edge of the ange on the spool. If it extends past the
ange, it won't t into the spool cover. Leave yourself 3
or 4 inches of line to work with.
b. Make sure that the two free ends of line are secured in
the opposite gaps on the spool ange.
c. While holding the ends in the gaps insert them through
the eyelets and slip the spool into the cover. Press
gently to ensure the spool is seated.
d. Pull straight out on the ends of the cutting line to
release them from the gaps.
e. Replace the cover on the cutting head and lock into
place by turning clockwise.
Winding the Line
NOTE: A dual-line factory wound spool (model TRJ607E-RS-6PK)
is available for easy spool replacement on the TRJ607E-RM
electric grass trimmer. Visit snowjoe.com to purchase this
accessory online. Should you wish to wind the line yourself, the
instructions are provided below. Self-winding, however, is NOT
recommended because if the line is not wound properly it can
cause the trimmer’s bump feed system to malfunction. For this
reason, users are strongly urged to purchase the pre-wound spool.
1. Unplug the grass trimmer.
2. To replace the line on a spool, follow these steps (Fig. 17):
a. Use approximately 12 ft. (3.7 m) of 0.063 in. (1.6 mm)
replacement line. Loop the line into 2 equal lengths
Fig. 12
Spool
cover
Spool
Fig. 13
Spring
Spool cover
Spool
Fig. 14
Spool
Spool cover
Eyelet
Spring
Fig. 15
Spool cover
Spool
Fig. 16
Eyelet
Spool
Spool cover
Loading ...
Loading ...
Loading ...