Loading ...
Loading ...
Loading ...
15
Replacing the Scraper Bar
IMPORTANT: Only use original replacement parts specied for
this snow blower.
You can purchase a replacement scraper bar (Model
24V-X2-20SB-SCRPR) and other genuine replacement parts
by visiting us online at snowjoe.com or calling our toll-free
customer service helpline at 1-866-SNOWJOE
(1-866-766-9563). The use of parts that do not meet the
original equipment specications may lead to improper
performance of the snow blower, may compromise operator
safety and will void the manufacturer's warranty.
1. Turn o the snow blower, remove the batteries and wait
until the snow blower comes to complete standstill.
2. Open the two side panels by removing the 8 screws on
each side (Fig. 21).
2. Raise the snow blower as shown. Remove the 6 screws
used to attach the scraper bar, and remove the worn
scraper bar (Fig. 22).
3. Fit the new scraper bar in place, secure with the original
6 screws (Fig. 22).
4. Replace the 2 side panels and x with the screws.
The snow blower is ready for use.
Replacing the Auger Blade
IMPORTANT: Only use original replacement parts specied for
this snow blower.
You can purchase a replacement auger blade (Model
24V-X2-20SB-AUGER) and other genuine replacement parts
by visiting us online at snowjoe.com or calling our toll-free
customer service helpline at 1-866-SNOWJOE
(1-866-766-9563). The use of parts that do not meet the
original equipment specications may lead to improper
performance of the snow blower, may compromise operator
safety and will void the manufacturer's warranty.
NOTE: When replacing worn auger blade, pay close attention
to any dierent types of bolts and nuts and where they are
positioned. This will ensure that all parts are installed properly
and securely.
1. Turn o the snow blower, remove the batteries and wait
until the snow blower comes to complete standstill.
2. Follow the instructions above to remove the 2 side panels
(Fig. 21).
3. From the left side of the snow blower, remove the belt
rst. Then use a hex wrench to loosen and remove the
pulley (Fig. 23).
4. From the right side of the snow blower, remove the nut
and screws used to x the metal plate, and then pull out
the metal plate with the axle. The auger will come o
(Figs. 24 – 25).
Screws
Fig. 21
Side panel Side panel Screws
Fig. 22
Scraper bar
Fig. 23
Belt
Pulley
Loading ...
Loading ...
Loading ...