Loading ...
Loading ...
Loading ...
5
8. INSTALL THE HOOD
1. Align the hood with the center line previously marked on the wall. Gently
lower the hood until it securely engages the screws on the wall.
2. Level the hood and completely tighten the screws on the wall.
3. Secure the hood to the wall by inserting 2 M4 x 38 Phillips 9 mm round head
mounting screws and 2 washers in the lower back of the hood (see back view
at right). Tighten both screws completely.
WARNING
!
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
6. REMOVE GREASE FILTERS
Lay the back side of the hood flat on a table. Use a piece of cardboard to
avoid damaging the table or the hood.
To remove the grease filters, pull down on the metal latch tab and tilt each
filter downward. Set filters aside.
HD1148
7. ADJUST THE HOOD MOUNTING BRACKETS
Both hood mounting brackets, located on top back corners of the unit, are
factory sent in down position (A). For each bracket, loosen both retaining
screws, then lift up bracket as shown in B, then tighten the screws.
BACK CORNER
HD1160
A
BACK CORNER
B
HOLE LOCATIONS
HD1164
Loading ...
Loading ...
Loading ...