Loading ...
Loading ...
Loading ...
9
13. REMOVE THE BLOWER (SINGLE BLOWER MODEL, HORIZONTAL DISCHARGE ONLY)
In order to ease the power pack alignment with horizontal ductwork, disassemble the blower from the power pack before installing it in the
custom hood.
HD0368
LEFT SIDE MOUNTING
SCREW LOCATIONS
HD0369
RIGHT SIDE MOUNTING
SCREW LOCATIONS
14. INSTALL THE POWER PACK
Using a 5/16” socket, or a Phillips no. 2 or a Robertson no. 2
screwdriver, remove all blower mounting screws from the inner top
of the power pack. Set blower and screws aside.
CAUTION
Take care not to kink ducting or pinch electrical cable when installing the power pack.
HD0370
CLASPING
SPRINGS
Insert the power pack in the custom hood until the bottom of the clasping springs (2 per side) rests on the
top of the custom hood base (grey zone in illustration at right).
HH0126
From inside the power pack, using provided no. 8-10 x 1/2” screws, mount the power pack to the
custom hood base. To do so, raise the front until its flange rests on the outer side of the custom hood
base and use 2 screws to secure in place. Do the same for the back, then complete the installation
with 2 additional screws on the front and back. See figure at right for mounting screws locations.
VERTICAL EXHAUST INSTALLATION ONLY
Ensure the adapter/damper enters the ducting and the damper opens freely. Wherever it is possible,
seal connections with metal foil duct tape.
Loading ...
Loading ...
Loading ...