Loading ...
Loading ...
Loading ...
Auxiliary Controls
Additional controls are located
behind the room cabinet.
Access to the controls is obtained
by removing the room cabinet.
To remove the room cabinet,
grasp it at both sides, lift up and
pull forward.
To replace the room cabinet,
position slots at bottom of room
cabinet onto tabs at bottom of
chassis. Tilt room cabinet inward,
lift it slightly, and position it so
clips at top hook onto front lip of
air discharge grille. Then press
room cabinet down to secure it.
VENT
OPEN
FAN
CONT
/
CLOSE
Ventilation Control
This knob is set at CLOSE at the
factory. When it is in this position,
the vent door is closed and only
indoor air is filtered, cooled or
heated and circulated by the air
conditioner.
Switching the knob to OPEN opens
the vent door to allow some outside
air to enter the room. However,
cooling or heating effectiveness is
reduced when the control is set at
OPEN, so we suggest you don’t
keep it there long.
L
,J~
CYCLE
Fan Cycle Switih
This switch is set at
CONTINUOUS at the factory to
provide continuous fan operation in
cool or heat modes. If you want the
fan to cycle on and off with the
compressor or resistance heater, set
the switch at CYCLE.
If the knob is not set all the way in
the CLOSE position, the vent light
will remain on.
4
Loading ...
Loading ...
Loading ...