Loading ...
Loading ...
Loading ...
Taking Care of the Unexpected
227
If the Battery Is Low
1.To prevent an accidental short circuit, turn the ignition switch OFF (
w
).
2.
Remove the battery cover (page 187).
3.
Using a fully charged 12-volt battery, connect the positive (+) side
of the jumper cable to the charged battery, and connect the
positive (+) side on the other end of the jumper cable to the
positive (+) terminal of vehicle battery.
4.
Connect the negative (-) side of the jumper cable to the charged battery, and
connect the negative (-) side on the other end of the jumper cable to the rear
final gear case (SXS520M2) or the upper muffler cover (SXS500M2).
5.
After starting the engine, remove the negative (-) sides of the jumper cable
from the vehicle and the charged battery. Then, remove the positive (+) sides
of the jumper cable from the vehicle battery and the charged battery.
6.
Install the battery cover.
• Do not let the positive (+) side of the jumper cable touch on the
negative (-) terminal.
• If the jumper cable is connected to the battery with the polarity reversed,
the battery can explode or the electrical system will be seriously damaged.
RIGHT REAR
SXS520M2
jumper
cable
charged
battery
rear final gear case
vehicle
battery
Loading ...
Loading ...
Loading ...