Loading ...
Loading ...
Loading ...
9
English
2. Moving the unit and setting it up.
Since the unit is very heavy (approximately 63 k• g), be careful to avoid back injuries. (The unit must be carried by two persons.)
Put the unit down slowly and carefully watch your step.•
Do not drag or push the unit in an installed state. •
The oor may be damaged.
Do not move the unit with a person sitting on it. •
Failure to observe this precaution may result in accidents or injuries due to the unit fallen down.
Lifting the unit to install and setup the unit
You may damage the oor by dropping the unit if you do not •
hold it correctly.
Using the wheels to move the unit
When moving the unit with the wheels, place a mat etc. on the oor. •
Failure to observe this may cause damage to the oor.
Hold the plastic part.
Do not hold here.
Doing so may result
in damage or injury.
Placement area
(place a mat, etc.)
Hook your ngers on the
stiff plastic part inside.
Place the controller and the
power cord on the seat.
After procedures 1 to 5 on page 11;
1) Press the
button to return
the back rest to its original position.
2)
Slide the power switch to the “off” position
and unplug the unit.
Place the controller
and the power cord
on the seat.
Hold the plastic part.
Mat, etc. Wheels
Do not hold here.
Doing so may result in dam-
age or injury.
Lift it no higher than waist height.
Connect the power cord to the unit
1) Check for dirt and damage on appliance inlet
of the power switch section and the
connector of the power cord.
2) Insert the connector into the appliance inlet.
3) Be sure to push the connector in all the way.
Appliance
inlet
Connector
Install the unit with the backrest away
from the wall.
Make sure the backrest does not touch the wall.
More than 10 cm
(When the backrest is fully upright)
At least 3 cm
(When the backrest is fully reclined)
EP-MA03.indb 9 2012/07/09 17:42:44
Loading ...
Loading ...
Loading ...